Indexes

Message Layouts
Session
PreTrade
Trade
PostTrade
Infrastructure

Component

ApplicationSequenceControl

ID1057
PedigreeAdded EP-1
The ApplicationSequenceControl is used for application sequencing and recovery. Consisting of ApplSeqNum (1181), ApplID (1180), ApplLastSeqNum (1350), and ApplResendFlag (1352), FIX application messages that carries this component block will be able to use application level sequencing. ApplID, ApplSeqNum and ApplLastSeqNum fields identify the application id, application sequence number and the previous application sequence number (in case of intentional gaps) on each application message that carries this block.
Field
Name
Type
Req'd
Comments
Pedigree
1180
Identifies the application with which a message is associated. Used only if application sequencing is in effect.
Added EP-1
1181
Application sequence number assigned to the message by the application generating the message. Used only if application sequencing is in effect. Conditionally required if ApplID has been specified.
Added EP-1
1350
The previous sequence number in the application sequence stream. Permits an application to publish messages with sequence gaps where it cannot be avoided. Used only if application sequencing is in effect. Conditionally required if ApplID has been specified
Added EP-1
1352
Used to indicate that a message is being sent in response to an Application Message Request. Used only if application sequencing is in effect. It is possible for both ApplResendFlag and PossDupFlag to be set on the same message if the Sender's cache size is greater than zero and the message is being resent due to a session level resend request.
Added EP-1

Orchimate Copyright 2026 Atomic Wire Technology Limited
Orchestra Copyright 2026 FIX Protocol Ltd
Terms of Use|Privacy Policy